Maxon WL7 Especificaciones descargar pdf (Pagina 14)

11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713

PATENTS PENDING

ADJUSTMENTS

MAT SWITCH ADJUSTMENT

2. Measure the height of the

Threshhold Plate as shown in

(FIG. 14-1B). If the height is

not 5/8”, do step 3. If the height

is already 5/8”, skip step 3, and

go on to step 4.

LIFT AT GROUND LEVEL

(RH SIDE SHOWN)

FIG. 14-1A

ILLUMINATED

POWER SWITCH

HEIGHT MEASUREMENT

(RH SIDE SHOWN)

FIG. 14-1B

1. Make sure power switch (FIG.

14-1A) is turned on

and illuminated. Low-

er Lift to the ground

(FIG. 14-1A).

5/8”

NOTE: Do this procedure if structure of the Lift is undamaged and:

• The Controller reads “MAT ERR” when the Threshold Plate is unoccupied

and Platform is below ﬂ oor level.

• The Threshold Warning Beacons and Threshold Warning Alarm are on

when Threshold is unoccupied and Platform below ﬂ oor level.

• The Threshold Warning Beacons and Threshold Warning Alarm will not turn

on when Threshold is occupied and Platform below ﬂ oor level.

• The MAT switch or Threshold Plate are removed & replaced.

The adjustment is done correctly if:

• The Controller does not read “MAT ERR” when the Threshold Plate is unoc-

cupied and Platform is below ﬂ oor level.

• The Threshold Warning Beacons and Threshold Warning Alarm are on

when Threshold is unoccupied and Platform below ﬂ oor level.

• The Threshold Warning Beacons and Threshold Warning Alarm turn on

when Threshold is occupied and Platform below ﬂ oor level.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 86 87

Sin comentarios

Maxon WL7 Especificaciones Pagina 14