Maxon MODMAX MM-6280IND Información técnica descargar pdf (Pagina 25)

Extended AT Commands Manual Page 25 of 70 2009-06-25

Command TE2

MT2 $$RINGIDX=<value>

Response TE2

MT2 <result_code> (OK | ERROR)

5.5. Network Relational Settings

5.5.1.1. Roaming indicator information (AT$$ROAMIND)

This command is used for reading Roaming Indicator Information.

Table 5-38 Read command

Command TE2

MT2 $$ROAMIND

Response TE2

MT2 $$ROAMIND: <value>

Value

0: Not Roaming

1: Roaming inside preferred roaming list

2: Roaming outside preferred roaming list

5.5.1.2. Antenna Signal Level report schedule (AT$$ANTSET)

The command is used for reading or setting the notification period of $$ANTLVL notification in

seconds. If no changes are monitored $$ANTLVL does not report to $$ANTSET values.

Table 5-39 Read command

Command TE2

MT2 $$ANTSET?

Response TE2

MT2 $$ANTSET: <value>

Value

0: Read once

1~43200: Notification every <x> seconds

Table 5-40 Set command

Command TE2

MT2 $$ANTSET=<value>

Response TE2

MT2 <result_code> (OK | ERROR)

5.5.1.3. Antenna Signal Level (AT$$ANTLVL)

The antenna level range is 0 (no service) to 7 (strong signal). If no changes are monitored

$$ANTLVL does not report to $$ANTSET values.

Table 5-41 Notification command

Notify TE2

MT2 $$ANTLVL: <value>

Value 0-7: 0 (no service) to 7 (strong signal)

If MT2 doesn’t receive a response (ACK) against ANTLVL, MT2 notifies two more times at the set

interval irrespective to any changes to the level.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 69 70

Sin comentarios

Maxon MODMAX MM-6280IND Información técnica Pagina 25