Maxon WL7-vers. C Especificaciones descargar pdf (Pagina 21)

11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713

PATENTS PENDING

PLATFORM TILT ADJUSTMENT

NOTE: Do this procedure if structure of the Lift is undamaged and:

• Outboard rollstop will not open completely when platform reaches the

ground.

• Bottoms of the vertical arms touch the ground before outboard rollstop.

• Platform is sloped down excessively toward the outboard rollstop.

The adjustment is done correctly if:

• Outboard rollstop opens completely when platform reaches the ground.

• Outboard rollstop will touch the ground before bottoms of vertical arms.

• Platform will slope down a little toward the outboard rollstop.

NOTE: The platform tilt adjustment is important for operation of the outboard

rollstop and for keeping platform level when it reaches the ground. The

lift mounting surface must be parallel to the ground and rigid enough to

remain parallel during the adjustment process. Platform must be empty

during adjustment. Lift mounting surface must be parallel to ground and

bed height must be 29”. Vehicle ﬂ oor height, Lift and stiffness of the ve-

hicle suspension may change the angle of platform on the ground.

PLATFORM AT GROUND LEVEL WITH VERTICAL

ARMS RESTING ON FLATS

FIG. 21-1

POWER

SWITCH

1. Make sure power switch

(FIG. 21-1) is turned on.

2. Lower platform to just

above the ground with

enough room to place a

1/4” steel ﬂ at under bot-

tom of LH and RH vertical arms

(FIG. 21-1). Then, lower plat-

form until outboard rollstop is all

the way open and verti-

cal arms rest on the 1/4”

ﬂ ats.

VERTICAL ARM

(RH SHOWN)

1/4” FLAT

GROUND

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 106 107

Sin comentarios

Maxon WL7-vers. C Especificaciones Pagina 21