Maxon MODMAX MM-6280IND Manual de usuario descargar pdf (Pagina 4)

Kingfisher PLUS+ Installation Manual 2.6

www.cse-semaphore.com/mykingfisher

Page 4

1. RTU Layout

The exact layout should be defined in layout and wiring drawings supplied with the RTU. If these have

not been supplied, then the RTU layouts shown below can be used as a guide.

Every RTU has a backplane (eg BA-4, BA-6), a power supply (eg PSU-3 or PS-11) and a processor

module (eg PC-1 or CP-11). The two common types of RTUs are shown below.

BA-6

12V DC

MAINS

POWER

PSU-3

BA-4

PC-1

MAINS

POWER

PS11

CP11

An RTU can have additional communications ports (MC-11) and a wide variety of input/output

modules (eg. IO-4, AI-1, DI-5). Some of these are shown below.

BA-6

12V DC

BA-4

MAINS

POWER

MAINS

POWER

PS11

PC-1

IO-4

MC11

AI-1

CP-11

CP11

MC11

DI-5

PSU-3

If a communications module is used, standard practice is to install it to the right of the processor. IO

modules are usually installed in alphabetical order from left to right. Eg an AI-1 module would be

located to the left of a DI-5 module. The modules can be installed in any order if so desired (except a

PC-1 must be installed in the leftmost slot of a BA-4 backplane since it has two sockets).

1 2 3 4 5 6 7 8 9 ... 25 26

Sin comentarios

Maxon MODMAX MM-6280IND Manual de usuario Pagina 4